2005-2008 RAV4 · Service Manual COMMUNICATION SYSTEM

ABS and Traction Actuator (Skid Control ECU) Communication Stop Mode

Circuit diagnosis · Vehicles built Nov 2005 – Jul 2008

Versions by build date: Nov 2005 – Jul 2008 from Aug 2008

DESCRIPTION

Detection Item
Symptom
Trouble Area
ABS AND TRACTION ACTUATOR (SKID CONTROL ECU) COMMUNICATION STOP MODE
  1. ABS/VSC/TRC is not displayed on "BUS CHECK" screen of intelligent tester
  2. Applies to "ABS AND TRACTION ACTUATOR (SKID CONTROL ECU) COMMUNICATION STOP MODE" in "DTC COMBINATION TABLE"
  1. Power source or inside skid control ECU
  2. ABS and traction actuator (skid control ECU) branch wire and connector
  3. ABS and traction actuator (skid control ECU)

HINT:
For vehicle with VSC only.


WIRING DIAGRAM

C132262E01

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of the main wire and the branch wire.
  2. For Auto:
    After the ignition switch is turned off, check that the key reminder warning system is not in operation.
  3. For Reminder:
    After the ignition switch is turned off, check that the key reminder warning system and light reminder buzzer are not in operation.
  4. Before measuring the resistance, leave the vehicle for at least 1 minute and do not operate the ignition switch, any switches or doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. CHECK CAN BUS LINE DISCONNECTION (ABS AND TRACTION ACTUATOR BRANCH WIRE)

  1. F100890E12
    Disconnect the A26 ABS and traction actuator (skid control ECU) connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A26-11 (CANH) - A26-25 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE ABS AND TRACTION ACTUATOR BRANCH WIRE AND CONNECTOR (CANH, CANL)
OK


2. CHECK WIRE HARNESS (ABS AND TRACTION ACTUATOR - BATTERY AND BODY GROUND)
F100890E13
  1. Disconnect the A26 ABS and traction actuator (skid control ECU) connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    A26-1 (GND2) - Body ground
    Below 1 Ω
    A26-32 (GND1) - Body ground
    Below 1 Ω

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A26-46 (IG1) - Body ground
    Ignition switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY


← Brake Actuator (Skid Control ECU) Communication Stop Mode (from Nov 2005)ABS and Traction Actuator (Skid Control ECU) Communication Stop Mode (from Aug 2008) →