2005-2008 RAV4 · Service Manual BRAKE

INSPECTION

Inspection · Vehicles built Nov 2005 – Jul 2008

Versions by build date: Nov 2005 – Jul 2008 from Aug 2008


INSPECT YAW RATE SENSOR OR DECELERATION SENSOR
  1. Inspect the yaw rate sensor or deceleration sensor. If any of the following occurs, replace the yaw rate sensor or deceleration sensor with a new one.

    1. The surface of the sensor is cracked, dented, or chipped off.
    2. The connector or wire harness is scratched, cracked, or damaged.
    3. The sensor has been dropped.


INSPECT DECELERATION SENSOR (w/o VSC)

  1. C108887E04
    Connect 3 dry cell batteries of 1.5 V in series.

  1. Connect the batteries' positive (+) lead to terminal 3 (VGS) and the negative (-) lead to terminal 2 (GGND).

  1. Connect the voltmeter's positive (+) lead to the negative (-) lead of the batteries, and the negative (-) lead to terminal 1 (GL1). Apply approximately 4.5 V.

    HINT:
    Do not apply 6 V or more to terminals 3 (VGS) and 2 (GGND).

  1. Check the output voltage of terminal 1 (GL1) when the sensor is tilted forward and rearward.

    Standard voltage:
    Tester Connection
    Sensor Position
    Specified Condition
    1 (GL1) - Battery's negative (-) lead
    Horizontal
    Approx. 2.5 V
    1 (GL1) - Battery's negative (-) lead
    Tilted forward
    Approx. 0.5 to 2.5 V
    1 (GL1) - Battery's negative (-) lead
    Tilted rearward
    Approx. 2.5 to 4.5 V

    If the result is not as specified, replace the sensor. When replacing the sensor, do not place the new sensor upside down.

← REMOVAL (from Aug 2008)INSPECTION (from Aug 2008) →