2005-2008 RAV4 · Service Manual BRAKE

INSPECTION

Inspection · Vehicles built from Aug 2008

Versions by build date: Nov 2005 – Jul 2008 from Aug 2008


CHECK YAW RATE SENSOR OR DECELERATION SENSOR
  1. Check the yaw rate sensor or deceleration sensor.
    Under any of the following conditions, replace the sensor with a new one.

    1. The surface of the sensor is cracked, dented, or chipped off.
    2. The connector or wire harness is scratched, cracked, or damaged.
    3. The sensor has been dropped.


INSPECT DECELERATION SENSOR (w/o VSC)

  1. C108887E04
    Connect 3 dry cell batteries of 1.5 V in series (approximately 4.5 V total).

  1. Connect the batteries' positive (+) lead to terminal 3 (VGS) and the negative (-) lead to terminal 2 (GGND).

    NOTICE:
    Do not apply 6 V or higher to terminals 3 (VGS) and 2 (GGND).

  1. Connect the voltmeter's positive (+) lead to the negative (-) lead of the batteries, and the negative (-) lead to terminal 1 (GL1).

  1. Check the output voltage of terminal 1 (GL1) when the sensor is tilted forward and rearward.

    Standard voltage:
    Tester Connection
    Sensor Position
    Specified Condition
    1 (GL1) - Battery's negative (-) lead
    Horizontal
    Approx. 2.25 V
    1 (GL1) - Battery's negative (-) lead
    Tilted forward
    Approx. 0.45 to 2.25 V
    1 (GL1) - Battery's negative (-) lead
    Tilted rearward
    Approx. 2.25 to 4.05 V

    If the result is not as specified, replace the deceleration sensor.

    HINT:
    1. If voltage drops, the sensor should be replaced with a new one.
    2. When replacing the sensor, it should not be placed upside down.

← INSPECTION (Nov 2005 – Jul 2008)INSTALLATION (Nov 2005 – Dec 2006) →