REMOVAL
Removal / installation · Vehicles built from Aug 2008
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2008 from Aug 2008
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
| 2.
REMOVE FRONT SEAT ASSEMBLY LH |
 |
for Manual Seat:
Remove the front seat LH (Click here).
for Power Seat:
Remove the front seat LH (Click here).
| 3.
REMOVE FRONT DOOR SCUFF PLATE LH
|
 |
- Using a screwdriver, detach the 10 claws and remove the scuff plate.
- HINT:
- Tape the screwdriver tip before use.
| 4.
REMOVE YAW RATE SENSOR BRACKET |
 |
Remove the bolt and yaw rate sensor bracket.


| 5.
REMOVE YAW RATE SENSOR ASSEMBLY (w/ VSC) |
 |
- Disconnect the yaw rate sensor connector.
Remove the 2 bolts and yaw rate sensor.
- NOTICE:
- Do not remove the sensor from the bracket.
| 6.
REMOVE DECELERATION SENSOR (w/o VSC) |
 |
- Disconnect the deceleration sensor connector.
Remove the 2 bolts and deceleration sensor.
- NOTICE:
- Do not remove the sensor from the bracket.