2005-2008 RAV4 · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Aug 2008

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008 from Aug 2008

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedures listed below are for the LH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


2. REMOVE REAR WHEEL

3. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
  1. Remove the deck trim side panel LH (Click here).

    HINT:
    Refer to the procedures from the removal of the rear door scuff plate LH up until the removal of the deck trim side panel LH.


4. REMOVE SKID CONTROL SENSOR WIRE

  1. C127328
    Disconnect the skid control sensor wire connector.

  1. C127970E01
    Disconnect the grommet of the skid control sensor wire from the hole of the wheel house.

  1. C127967E01
    Remove the bolt (labeled A) and sensor clamp (labeled B) from the side member.

  1. Remove the 2 nuts (labeled C) and 2 sensor clamps (labeled D) from the upper arm.

  1. C127966E01
    Remove the bolt (labeled E) and sensor clamp (labeled F) from the carrier.

  1. Disconnect the skid control sensor wire connector (labeled G) from the skid control sensor.


5. REMOVE REAR DISC BRAKE CYLINDER MOUNTING LH

  1. C127287
    Remove the 2 bolts and cylinder mounting.


6. REMOVE REAR DISC

  1. C129072E01
    Put matchmarks on the disc and axle hub.

  1. Release the parking brake.

  1. C127304
    Turn the shoe adjuster until the disc turns freely, and then remove the disc.

  1. Install the shoe adjusting hole plug to the rear disc.


7. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH (SKID CONTROL SENSOR)
  1. Remove the rear axle hub and bearing LH (Click here).

← REMOVAL (Aug 2007 – Jul 2008)INSPECTION (Nov 2005 – Jul 2008) →