2005-2008 RAV4 · Service Manual BODY ELECTRICAL

Illumination Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

The radio and navigation assembly panel and steering pad switch illuminates when the light control switch is in the TAIL or HEAD position.

WIRING DIAGRAM

I102031E01

INSPECTION PROCEDURE

NOTICE:
The vehicle is equipped with an SRS such as the airbag. Before servicing (including removal or installation of parts), be sure to read the precautionary notice for the airbag system (Click here).


1. CHECK WIRE HARNESS (RADIO AND NAVIGATION ASSEMBLY - BATTERY AND BODY GROUND)

  1. E106746E07
    Disconnect the E52 radio connector.

  1. Measure the voltage and resistance of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E52-10 (ILL+) - Body ground
    Ignition Switch on (IG), light control switch TAIL or HEAD
    10 to 14 V

    Standard resistance:
    Tester Connection
    Specified Condition
    E52-7 (GND) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2. CHECK VEHICLE EQUIPMENT
  1. Check if the steering pad switch is equipped on the vehicle.

    Result 
    Result
    Proceed to
    w/ Steering pad switch
    A
    w/o Steering pad switch
    B



B
PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE
A


3. INSPECT STEERING PAD SWITCH ASSEMBLY (ILLUMINATION)
I102053E01
  1. Disconnect the switch connector.

  1. Connect the battery's positive (+) lead to terminal 5 and the negative (-) lead to terminal 8 of the switch connector.

  1. Check the illumination of the switch.

    OK:
    Illumination for the steering pad switch turns on.



NG
REPLACE STEERING PAD SWITCH ASSEMBLY
OK


Go to step 5

4. CHECK WIRE HARNESS (STEERING PAD SWITCH - RADIO AND NAVIGATION ASSEMBLY AND BATTERY)

  1. I101971E01
    Disconnect the E10 cable connector.

  1. Disconnect the E56 radio connector.

  1. Measure the resistance and voltage of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E10-4 (EAU) - E56-6 (SWG)
    Below 1 Ω

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E10-12 (IL+2) - Body ground
    Light control switch TAIL or HEAD
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


5. INSPECT SPIRAL CABLE SUB-ASSEMBLY

  1. I102015E04
    Disconnect the cable connectors.

  1. Measure the resistance of the cable.

    Standard resistance:
    Tester Connection
    Specified Condition
    E10-4 (EAU) - 8 (EAU)
    Below 1 Ω
    E10-12 (IL+2) - 5 (IL+2)
    Below 1 Ω



NG
REPLACE SPIRAL CABLE SUB-ASSEMBLY
OK

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE


← Steering Pad Switch Circuit (from Nov 2005)Speaker Circuit (from Nov 2005) →