2005-2008 RAV4 · Service Manual BODY ELECTRICAL

Speed Signal Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

This circuit sends a speed signal from the combination meter to the radio and navigation assembly.

WIRING DIAGRAM

I102036E05

INSPECTION PROCEDURE


1. CHECK OPERATION OF SPEEDOMETER
  1. Drive the vehicle and check if the function of the speedometer on the combination meter is normal.

    OK:
    Actual vehicle speed and the speed indicated on the speedometer are the same.

    HINT:
    The vehicle speed sensor is functioning normally when the indication on the speedometer is normal.



NG
GO TO METER / GAUGE SYSTEM
OK


2. CHECK WIRE HARNESS (RADIO AND NAVIGATION ASSEMBLY - COMBINATION METER)

  1. I102037E01
    Disconnect the E57 radio connector.

  1. Disconnect the E22 meter connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E57-3 (SPD) - E22-39 (+S)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE


← Speaker Circuit (from Nov 2005)Microphone Circuit between Overhead J/B and Multi-display (from Nov 2005) →