C1297/97 Steering Angle Sensor
Diagnostic trouble codes · Vehicles built Aug 2007 – Jul 2008
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008 from Aug 2008
DESCRIPTION
- The 4WD control ECU determines that the vehicle is turning based on the signals sent from the steering angle sensor.
- The steering angle sensor signal is sent to the 4WD control ECU via the CAN communication system.
- The 4WD control ECU detects the amount of steering wheel movement and performs "slip control at vehicle start up", according to the amount of movement, and "slip control" to secure high turning performance.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| C1297/97 |
When voltage of 4WD control ECU IG1 terminal is 9.5 V or more, and steering angle sensor malfunction signal is received. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- Check the condition of each related circuit connector before troubleshooting (Click here).
| 1. CHECK FOR DTC |
Clear the DTC (Click here).
Turn the ignition switch off.
Turn the ignition switch on (IG) again and check that no CAN communication system DTC(s) is output.
Start the engine.
Drive the vehicle and turn the steering wheel to the right and left at a speed of 35 km/h (22 mph) and check that no brake control system (steering angle sensor) DTC (C1231/31) is output (Click here).
- Result:
Result
Proceed to
Neither CAN communication system DTC nor brake control system DTC is output
A
CAN communication system DTC is output
B
Brake control system (steering angle sensor) DTC (C1231/31) is output
C
- HINT:
- When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding sensor.
|
|
||||
|
|
||||
| A | |
| 2. CHECK WIRE HARNESS (STEERING ANGLE SENSOR - BATTERY) |
![]() ![]() |
Disconnect the E14 sensor connector.
Measure the voltage of the wire harness side connector.
- Standard voltage:
Tester Connection
Condition
Specified Condition
E14-1 (IG) - Body ground
Ignition switch on (IG)
10 to 14 V
E14-3 (BAT) - Body ground
Always
10 to 14 V
|
|
||||
| OK | |
| 3. CHECK WIRE HARNESS (STEERING ANGLE SENSOR - BODY GROUND) |
![]() ![]() |
Disconnect the E14 sensor connector.
Measure the resistance of the wire harness side connector.
- Standard resistance:
Tester Connection
Specified Condition
E14-2 (ESS) - Body ground
Below 1 Ω
- Result:
Result
Proceed to
OK (When troubleshooting according to DTC chart)
A
OK (When troubleshooting according to PROBLEM SYMPTOMS TABLE)
B
NG
C
|
|
||||
|
|
||||
| A | ||
| ||


