The 4WD control ECU is connected to the combination meter via the CAN communication system.
w/ Multi-information display: If the 4WD control ECU stores any DTCs which are related to the active torque control system, the meter caution indicator light comes on and the warning message is displayed on the multi-information display in the combination meter.
w/o Multi-information display: If the 4WD control ECU stores any DTCs which are related to the active torque control system, the 4WD indicator light comes on in the combination meter.
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT:
Check the condition of each related circuit connector before troubleshooting (Click here).
Neither CAN communication system DTC nor 4WD control system DTC is output
A
CAN communication DTC is output
B
4WD control system DTC is output
C
HINT:
When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding sensor.
B
REPAIR CIRCUIT INDICATOR BY OUTPUT CODE (CAN COMMUNICATION SYSTEM)
C
REPAIR CIRCUIT INDICATOR BY OUTPUT CODE (4WD CONTROL SYSTEM)
A
2. PERFORM ACTIVE TEST BY INTELLIGENT TESTER (4WD INDICATOR LIGHT)
Using the intelligent tester's Active Test, generate a control command, and then check that the 4WD indicator light operates.
Combination meter:
Item
Test Details
Diagnostic Note
4WD Indicator Light
4WD indicator light OFF
Observer combination meter
OK:
The 4WD indicator light turns OFF
OK
REPLACE 4WD CONTROL ECU
NG
3. CHECK WIRE HARNESS (4WD CONTROL ECU - BATTERY)
Disconnect the E67 ECU connector.
Measure the voltage of the wire harness side connector.