2005-2008 RAV4 · Service Manual DRIVE LINE

4WD Indicator Light Remains ON

Circuit diagnosis · Vehicles built from Aug 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007

DESCRIPTION

The 4WD control ECU is connected to the combination meter via the CAN communication system.
  1. w/ Multi-information display:
    If the 4WD control ECU stores any DTCs which are related to the active torque control system, the meter caution indicator light comes on and the warning message is displayed on the multi-information display in the combination meter.
  1. w/o Multi-information display:
    If the 4WD control ECU stores any DTCs which are related to the active torque control system, the 4WD indicator light comes on in the combination meter.

WIRING DIAGRAM

C135112E01
C131923E06

INSPECTION PROCEDURE

HINT:
Check the condition of each related circuit connector before troubleshooting (Click here).


1. CHECK FOR DTC
  1. Check the output DTC (Click here).


Result:
Result
Proceed to
Neither CAN communication system DTC nor 4WD control system DTC is output
A
CAN communication DTC is output
B
4WD control system DTC is output
C

HINT:
When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding sensor.



B
REPAIR CIRCUIT INDICATOR BY OUTPUT CODE (CAN COMMUNICATION SYSTEM)

C
REPAIR CIRCUIT INDICATOR BY OUTPUT CODE (4WD CONTROL SYSTEM)
A


2. PERFORM ACTIVE TEST BY INTELLIGENT TESTER (4WD INDICATOR LIGHT)
  1. Using the intelligent tester's Active Test, generate a control command, and then check that the 4WD indicator light operates.

    Combination meter:
    Item
    Test Details
    Diagnostic Note
    4WD Indicator Light
    4WD indicator light OFF
    Observer combination meter

    OK:
    The 4WD indicator light turns OFF



OK
REPLACE 4WD CONTROL ECU
NG


3. CHECK WIRE HARNESS (4WD CONTROL ECU - BATTERY)
C107387E07
  1. Disconnect the E67 ECU connector.

  1. Measure the voltage of the wire harness side connector.

Voltage:
Tester Connection
Condition
Specified Condition
E67-11 (IG1) - Body ground
Ignition switch on (IG)
10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4. CHECK COMBINATION METER
  1. Check the combination meter (Click here).

    OK:
    The combination meter is normal.



NG
REPLACE COMBINATION METER
OK

REPLACE 4WD CONTROL ECU


← 4WD Indicator Light Remains ON (Jan 2007 – Jul 2007)4WD Indicator Light does not Come ON (Nov 2005 – Dec 2006) →