Rear Fog Light Circuit
Circuit diagnosis · Vehicles built from Nov 2005
DESCRIPTION
The main body ECU controls the rear fog light relay (marking: RR FOG) when a signal is received from the headlight dimmer switch.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (MAIN BODY ECU) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and press the intelligent tester main switch ON.
Select the item below in the ACTIVE TEST and then check that the relay operates.
Main body ECU Item
Test Details
Diagnostic Note
R Fog Light Rly
Turn rear fog light relay: ON / OFF
-
- OK:
- Headlights (LOW) come on.
|
|
||||
| NG | |
| 2. CHECK TAILLIGHT |
Check that the taillights come on when the light control switch is turned on (TAIL).
- OK:
- Taillights come on.
|
|
||||
| OK | |
| 3. INSPECT FUSE (RR FOG) |
Remove the RR FOG fuse from the instrument panel junction block.
Measure the resistance of the fuse.
- Standard resistance:
- Below 1 Ω
|
|
||||
| OK | |
| 4. INSPECT REAR FOG LIGHT BULB |
Remove the rear fog light bulb.
Connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 1, then check that the bulb illuminates.
- OK:
- Bulb illuminates.
|
|
||||
| OK | |
| 5. INSPECT REAR FOG LIGHT RELAY (Marking: RR FOG) |
![]() ![]() |
Remove the rear fog light relay from the No. 6 relay block.
Measure the resistance of the relay.
- Standard resistance:
Tester Connection
Specified Condition
3 - 5
10 kΩ or higher
3 - 5
Below 1 Ω
(Battery voltage applied to terminals 1 and 2)
|
|
||||
| OK | |
| 6. CHECK WIRE HARNESS (MAIN BODY ECU - BATTERY) |
![]() ![]() |
Disconnect the E19 ECU connector.
Measure the voltage of the wire harness side connector.
- Standard voltage:
Tester Connection
Condition
Specified Condition
E19-2 (RFGO) - Body ground
Light control switch on (TAIL)
10 to 14 V
|
|
||||
| OK | |
| 7. CHECK WIRE HARNESS (REAR FOG LIGHT RELAY - BATTERY) |
![]() ![]() |
Remove the rear fog light relay from the No. 6 relay block.
Measure the voltage of the relay block.
- Standard voltage:
Tester Connection
Specified Condition
Relay block rear fog light relay terminal 5 - Body ground
10 to 14 V
|
|
||||
| OK | |
| 8. CHECK WIRE HARNESS (REAR FOG LIGHT - BATTERY AND BODY GROUND) |
![]() ![]() |
Disconnect the N1*1 and N5*1 or S11*2 rear fog light connectors.
- HINT:
- *1: for Short Body
- *2: for Long Body
Measure the resistance of the wire harness side connectors and relay block.
- Standard resistance:
for short body Tester Connection
Specified Condition
Relay block rear fog light relay terminal 3 - N1-2
Below 1 Ω
Relay block rear fog light relay terminal 3 or N1-2 - Body ground
10 kΩ or higher
Relay block rear fog light relay terminal 3 - N5-2
Below 1 Ω
Relay block rear fog light relay terminal 3 or N5-2 - Body ground
10 kΩ or higher
N1-1 - Body ground
Below 1 Ω
N5-1 - Body ground
Below 1 Ω
for long body Tester Connection
Specified Condition
Relay block rear fog light relay terminal 3 - S11-2
Below 1 Ω
Relay block rear fog light relay terminal 3 or S11-2 - Body ground
10 kΩ or higher
S11-1 - Body ground
Below 1 Ω
|
|
||||
| OK | ||
| ||
| 9. CHECK WIRE HARNESS (DIMMER SWITCH - MAIN BODY ECU AND BODY GROUND) |
Disconnect the E15 headlight dimmer switch connector.
Disconnect the E20 main body ECU connector.


Measure the resistance of the wire harness side connectors.
- Standard resistance:
for LH side Tester Connection
Specified Condition
E20-9 (RFOG) - E15-2 (B)
Below 1 Ω
E20-9 (RFOG) or E15-2 (B) - Body ground
10 kΩ or higher
for RH side Tester Connection
Specified Condition
E20-9 (RFOG) - E15-9 (B)
Below 1 Ω
E20-9 (RFOG) or E15-9 (B) - Body ground
10 kΩ or higher
|
|
||||
| OK | |
| 10. INSPECT REAR FOG LIGHT SWITCH |
![]() ![]() |
Remove the headlight dimmer switch.
Measure the resistance of the switch.
- Standard resistance:
for LH side Tester Connection
Condition
Specified Condition
2 (B) - 12 (EL)
Fog light switch OFF
10 kΩ or higher
2 (B) - 12 (EL)
Fog light switch ON
Below 1 Ω
for RH side Tester Connection
Condition
Specified Condition
9 (B) - 19 (EL)
Fog light switch OFF
10 kΩ or higher
9 (B) - 19 (EL)
Fog light switch ON
Below 1 Ω
|
|
||||
| OK | ||
| ||





