2005-2008 RAV4 · Service Manual BODY ELECTRICAL

U0100 Lost Communication with ECM / PCM "A"

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

The combination meter assembly and the ECM exchange signals through the CAN communication system.
DTC No.
DTC Detection Conditions
Trouble Areas
U0100
When either of following conditions detected:
  1. Vehicle speed 5 km/h (3.1 mph) or more and IG voltage 10.5 V or more
  2. No communication with ECM continues for 3 seconds or more
    (No communication to ECM or skid control ECU continues for 60 seconds or more)
  1. CAN communication system
  2. ECM

WIRING DIAGRAM

E124226E01

INSPECTION PROCEDURE


1. CONFIRM DTC OUTPUT
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Clear the stored DTCs by selecting the following menu items on the tester: Body / Combination Meter / DTC / Clear.

  1. Drive the vehicle at more than 5 km/h (3.1 mph) for at least 60 seconds.

  1. Stop the vehicle.

  1. Check for DTCs.

    Result 
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
SYSTEM IS OK
A

GO TO CAN COMMUNICATION SYSTEM


← ON-VEHICLE INSPECTION (from Nov 2005)U0129 Lost Communication with Skid Control ECU (from Nov 2005) →