U0129 Lost Communication with Skid Control ECU
Diagnostic trouble codes · Vehicles built from Nov 2005
DESCRIPTION
The combination meter assembly receivers signal from ABS and traction actuator*1 (skid control ECU) or brake actuator*2 (skid control ECU) through the CAN communication system.| DTC No. |
DTC Detection Conditions |
Trouble Areas |
| U0129 |
When either of following conditions detected;
|
|
- HINT:
- *1: w/ VSC
- *2: w/o VSC
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CONFIRM DTC OUTPUT |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Clear the stored DTCs by selecting the following menu items on the tester: Body / Combination Meter / DTC / Clear.
Start the engine and wait for at least 60 seconds.
Check for DTCs.
Result Result
Proceed to
DTC output
A
DTC not output
B
|
|
||||
| A | ||
| ||
