HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007
- HINT:
- Use these procedures to troubleshoot the active torque control 4WD system.
- *: Use the intelligent tester.
- Use these procedures to troubleshoot the active torque control 4WD system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
| |||||
| 3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Use the intelligent tester to check if the CAN communication system is functioning normally.
Result Result
Proceed to
CAN DTC is not output
A
CAN DTC is output
B
|
|||||
| |||||
| 4.CHECK INDICATOR LIGHT |
| |||||
| 5.CHECK DTC* |
Check for DTCs (Click here).
Clear the DTCs.
Recheck for DTCs.
| Result |
Proceed to |
| DTC dose not reoccur |
A |
| DTC dose reoccur |
B |
|
|||||
| |||||
| 6.PROBLEM SYMPTOMS TABLE |
| Result |
Proceed to |
| Fault not listed in problem symptoms table |
A |
| Fault listed in problem symptoms table |
B |
|
|||||
| |||||
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Terminals of ECU (Click here).
Data List / Active Test (Click here).
| |||||
| 8.REPAIR OR REPLACE |
| |||||
| 9.CONFIRMATION TEST |
| |||||