2005-2008 RAV4 · Service Manual BODY ELECTRICAL

Tachometer Malfunction

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

The combination meter assembly controls the tachometer in accordance with engine speed signals from the ECM through the CAN communication system.

WIRING DIAGRAM

E124226E01

INSPECTION PROCEDURE

HINT:
If DTC U0100 has been stored, troubleshoot the CAN communication system first.


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (TachoMeter Operation)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Perform the Active Test according to the prompts displayed on the tester.

    Combination meter 
    Item
    Tester Details
    Diagnostic Note
    TachoMeter Operation
    0 / 1,000 / 2,000 / 3,000 / 4,000 / 5,000 / 6,000 / 7,000 rpm
    Value selected during Active Test is displayed

    OK:
    Engine speed displayed on the tester is almost the same as that of the tachometer reading.



NG
REPLACE COMBINATION METER ASSEMBLY
OK


2. READ VALUE USING DATA LIST (Engine Rpm)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Read the Data List according to the prompts displayed on the tester.

    Combination meter 
    Item
    Measurement Item / Range (Display)
    Normal Condition
    Diagnostic Note
    Engine Rpm
    Engine speed / Min.: 0 rpm, Max.: 12,750 rpm
    Almost same as actual engine speed
    (When engine is running)
    -

    OK:
    Engine speed displayed on the tester is almost the same as the actual engine speed.



NG
REPLACE COMBINATION METER ASSEMBLY
OK

GO TO SFI or ECD SYSTEM


← Speedometer Malfunction (from Nov 2005)Fuel Receiver Gauge Malfunction (from Nov 2005) →