2005-2008 RAV4 · Service Manual BODY ELECTRICAL

Fuel Receiver Gauge Malfunction

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

The combination meter assembly controls the fuel receiver gauge in accordance with the resistance of the fuel sender gauge that varies depending on the amount of fuel remaining in the fuel tank.

WIRING DIAGRAM

E124225E01

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (Fuel Meter Operation)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Perform the ACTIVE TEST according to the prompts displayed on the tester.

    Combination meter 
    Item
    Test Details
    Diagnostic Note
    Fuel Meter Operation
    EMPTY / 1/2 / FULL
    Value selected during Active Test is displayed

    OK:
    Value selected during Active Test is displayed.



NG
REPLACE COMBINATION METER ASSEMBLY
OK


2. READ VALUE USING DATA LIST (Fuel Input (A/D))
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and the tester ON.

  1. Read the Data List according to the prompts displayed on the tester.

    Combination meter 
    Item
    Measurement Item / Range (Display)
    Normal Condition
    Diagnostic Note
    Fuel Input (A/D)
    Fuel input signal / Min.: 0, Max.: 255
    Fuel gauge indicates (F): 33
    Fuel gauge indicates (3/4): 98
    Fuel gauge indicates (1/2): 144
    Fuel gauge indicates (1/4): 179
    Fuel gauge indicates (E): 206
    -

    OK:
    Meter / gauge value and tester value are the same.



NG
REPLACE COMBINATION METER ASSEMBLY
OK


3. INSPECT FUEL SENDER GAUGE ASSEMBLY
  1. Remove the fuel sender gauge.

  1. E126940E01
    Measure the resistance of the gauge.

    Standard resistance:
    Tester Connection
    Float Level
    Specified Condition
    1 - 2
    F
    15.0 +-1.5 Ω
    1 - 2
    1/2
    212.5 +-12.2 Ω
    1 - 2
    E
    410.0 +-4.5 Ω



NG
REPLACE FUEL SENDER GAUGE ASSEMBLY
OK


4. CHECK WIRE HARNESS (COMBINATION METER - FUEL SENDER GAUGE)

  1. E124246E02
    Disconnect the E22 meter connector.

  1. Disconnect the T2 gauge connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E22-25 (L) - T2-1 (FS)
    Below 1 Ω
    E22-12 (E) - T2-2 (EF)
    Below 1 Ω
    E22-25 (L) or T2-1 (FS) - Body ground
    10 kΩ or higher
    E22-12 (E) or T2-2 (EF) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY


← Tachometer Malfunction (from Nov 2005)Engine Coolant Temperature Receiver Gauge Malfunction (from Nov 2005) →