Engine Coolant Temperature Receiver Gauge Malfunction
Circuit diagnosis · Vehicles built from Nov 2005
DESCRIPTION
The combination meter assembly receives the engine coolant temperature sensor signal from the ECM and displays it using CAN communication.WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- If DTC U0100 has been stored, troubleshoot the CAN communication system first.
- If there is an open or short in the engine coolant temperature sensor circuit, an SFI or ECD system DTC is output. If output, perform troubleshooting on the SFI or ECD system.
- If DTC U0100 has been stored, troubleshoot the CAN communication system first.
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (Water Temperature Meter Operation) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Perform the ACTIVE TEST according to the prompts displayed on the tester.
Combination meter Item
Test Details
Diagnostic Note
Water Temperature Meter Operation
LOW / NORMAL / HIGH
Value selected during Active Test is displayed
- OK:
- Value selected during Active Test is displayed.
|
|
||||
| OK | |
| 2. READ VALUE USING DATA LIST (Coolant Temperature) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and the tester ON.
Read the Data List according to the prompts displayed on the tester.
Combination meter Item
Measurement Item / Range (Display)
Normal Condition
Diagnostic Note
Coolant Temperature
Coolant temperature / Min.: 0°C (32°F), Max.: 127.5°C (261.5°F)
After warming up: 80 to 95°C (176 to 203°F)
If the value is "0°C (32°F)" or "127.5°C (261.5°F)", sensor circuits are open or shorted.
- OK:
- Vehicle's coolant temperature and tester value are the same.
|
|
||||
| OK | ||
| ||
