The downhill assist control switch is connected to the skid control ECU in the ABS and TRACTION actuator. DTC C1379/74 can be detected when the downhill assist control switch sends the downhill assist control switch signal or test mode ends. DTC C1379/74 is output only in test mode.
DTC No. DTC
DTC Detection Condition
Trouble Area
C1379/74
Detected only during test mode.
Downhill assist control switch
WIRING DIAGRAM
Refer to the downhill assist control indicator light circuit (Click here).
INSPECTION PROCEDURE
NOTICE:
When replacing the ABS and TRACTION actuator, perform zero point calibration (Click here).
1. CHECK WIRE HARNESS (SKID CONTROL ECU - BODY GROUND)
Disconnect the A26 ECU.
Measure the resistance of the wire harness side connector.
Standard resistance:
Tester Connection
Switch Condition
Specified Condition
A26-28 (HDCS) - Body ground
Downhill assist control switch is not pushed
10 kΩ or higher
OK
REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY
NG
2. INSPECT DOWNHILL ASSIST CONTROL SWITCH
Remove the downhill assist control switch.
Measure the resistance of the switch.
Standard resistance:
Tester Connection
Switch Condition
Specified Condition
1 - 4
Switch is pushed
Below 1 Ω
1 - 4
Switch is not pushed
10 kΩ or higher
NG
REPLACE DOWNHILL ASSIST CONTROL SWITCH
OK
3. CHECK WIRE HARNESS (SKID CONTROL ECU - DOWNHILL ASSIST CONTROL SWITCH)
Disconnect the A26 ECU connector.
Disconnect the E36 switch connector.
Measure the resistance of the wire harness side connectors.