2005-2008 RAV4 · Service Manual BRAKE

C1379/74 Downhill Assist Control Operation Switch (Test Mode DTC)

Diagnostic trouble codes · Vehicles built Nov 2005 – Dec 2006

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008

DESCRIPTION

The downhill assist control switch is connected to the skid control ECU in the ABS and TRACTION actuator.
DTC C1379/74 can be detected when the downhill assist control switch sends the downhill assist control switch signal or test mode ends. DTC C1379/74 is output only in test mode.
DTC No. DTC
DTC Detection Condition
Trouble Area
C1379/74
Detected only during test mode.
Downhill assist control switch

WIRING DIAGRAM

Refer to the downhill assist control indicator light circuit (Click here).

INSPECTION PROCEDURE

NOTICE:
When replacing the ABS and TRACTION actuator, perform zero point calibration (Click here).


1. CHECK WIRE HARNESS (SKID CONTROL ECU - BODY GROUND)

  1. C121700E37
    Disconnect the A26 ECU.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    A26-28 (HDCS) - Body ground
    Downhill assist control switch is not pushed
    10 kΩ or higher



OK
REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY
NG


2. INSPECT DOWNHILL ASSIST CONTROL SWITCH

  1. C128533E06
    Remove the downhill assist control switch.

  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 4
    Switch is pushed
    Below 1 Ω
    1 - 4
    Switch is not pushed
    10 kΩ or higher



NG
REPLACE DOWNHILL ASSIST CONTROL SWITCH
OK


3. CHECK WIRE HARNESS (SKID CONTROL ECU - DOWNHILL ASSIST CONTROL SWITCH)
C131804E02
  1. Disconnect the A26 ECU connector.

  1. Disconnect the E36 switch connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    A26-28 (HDCS) - E36-4
    Below 1 Ω
    E36-4 - Body ground
    Below 1 Ω
    A26-28 (HDCS) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY


← C1379 Downhill Assist Control Switch Malfunction (Test Mode DTC) (from Aug 2008)C1379/74 Downhill Assist Control Operation Switch (Test Mode DTC) (Jan 2007 – Jul 2007) →