2005-2008 RAV4 · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Aug 2007


1. INSTALL ENGINE REAR OIL SEAL

  1. A132245E01
    Apply MP grease to a new oil seal lip.

  1. Using SST and a hammer, tap in the oil seal.

    SST
    09223-15030  
    09950-70010   (09951-07150)

    Oil seal tap in depth:
    -0.5 to 0.5 mm (-0.020 to 0.020 in.)


2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

  1. A054047E01
    Clean the bolt and its hole.

  1. Apply adhesive to 2 or 3 threads of the bolt end.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

  1. A182507E01
    Using SST, hold the crankshaft.
    SST
    09213-70011   (09213-70020)
    09330-00021  

  1. Install the flywheel, drive plate and drive plate spacer on the crankshaft.

  1. A173966E01
    Uniformly install and tighten the 8 bolts in the sequence shown in the illustration.

    Torque:
    83 N*m{ 847 kgf*cm , 61 ft.*lbf }

    NOTICE:
    Do not start the engine for at least 1 hour after the installation.


3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY

HINT:
Install the automatic transaxle assembly (Click here).

← REMOVAL (from Aug 2007)COMPONENTS (from Aug 2007) →