2005-2008 RAV4 · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built from Aug 2007

Versions by build date: Nov 2005 – Jul 2007 from Aug 2007

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. TEMPORARILY TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY LH

  1. C127555
    Temporarily install the suspension arm with the bolt and 2 nuts to the suspension member and axle carrier.


2. INSTALL REAR WHEEL
  1. Install the wheel.

    Torque:
    103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }


3. TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY
  1. Install the nut and 2 bolts.

    Torque:
    90 N*m{ 918 kgf*cm , 66 ft.*lbf } for bolt
    100 N*m{ 1,020 kgf*cm , 74 ft.*lbf } for nut

    NOTICE:
    For the nut on the rear suspension member side, do not tighten the nut.


4. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
  1. Inspect and adjust the rear wheel alignment (Click here).

← INSTALLATION (Nov 2005 – Jul 2007)COMPONENTS (from Nov 2005) →