INSTALLATION
Removal / installation · Vehicles built Nov 2005 – Jul 2007
Versions by build date: Nov 2005 – Jul 2007 from Aug 2007
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- Use the same procedures for the RH side and LH side.
| 1. TEMPORARILY TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY LH |
Temporarily install the suspension arm with the bolt and 2 nuts to the suspension member and axle carrier.

| 2. INSTALL REAR WHEEL |
Install the wheel.
- Torque:
- 103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }
| 3. TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY |
Install the nut and 2 bolts.
- Torque:
- 90 N*m{ 918 kgf*cm , 66 ft.*lbf } for bolt
- 100 N*m{ 1,020 kgf*cm , 74 ft.*lbf } for nut
- NOTICE:
- For the nut on the rear suspension member side, do not tighten the nut.
| 4. INSPECT AND ADJUST REAR WHEEL ALIGNMENT |
Inspect and adjust the rear wheel alignment (Click here).
