C0273/13 Open in ABS Motor Relay Circuit
Diagnostic trouble codes · Vehicles built Nov 2005 – Dec 2006
Also covers:
- C0274/14 Short to B+ in ABS Motor Relay Circuit
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007
DESCRIPTION
The ABS motor relay supplies the power to the ABS pump motor. While the ABS is activated, the ECU turns the motor relay ON and operates the ABS pump motor.| DTC No. |
DTC Detection Condition |
Trouble Area |
| C0273/13 |
When either condition below is met:
|
|
| C0274/14 |
When motor relay off, motor relay remains closed for 4 seconds or more. |
|
- HINT:
- C0273/13 and C0274/14: The skid control ECU begins to detect these DTCs when the vehicle speed exceeds 6 km/h (4 mph).
WIRING DIAGRAM
Refer to DTC C0226/21, C0236/22, C0246/23, C0256/24 (Click here).INSPECTION PROCEDURE
| 1. INSPECT FUSE (ABS1) |
Remove the ABS1 H-fuse from the engine room No. 1 relay block.
Measure the resistance of the fuse.
- Standard resistance:
- Below 1 Ω
|
|
||||
| OK | |
| 2. CHECK WIRE HARNESS (SKID CONTROL ECU - BATTERY AND BODY GROUND) |
Disconnect the A27 ECU connector.

Measure the voltage of the wire harness side connector.
- Standard voltage:
Tester Connection
Specified Condition
A27-23 (+BM) - Body ground
10 to 14 V
Measure the resistance of the wire harness side connector.
- Standard resistance:
Tester Connection
Specified Condition
A27-2 (GND1) - Body ground
Below 1 Ω
A27-24 (GND2) - Body ground
Below 1 Ω
|
|
||||
| OK | |
| 3. PERFORM ACTIVE TEST BY INTELLIGENT TESTER (MOTOR RELAY) |
Select the Active Test, generate a control command, and then check that the motor relay operates.
Skid control ECU Item (Display)
Vehicle Condition / Test Details
Diagnostic Note
Motor Relay
Turns ABS motor relay ON / OFF
Operating sound of motor can be heard
- OK:
- Operation sound of the ABS motor is heard.
|
|
||||
| OK | |
| 4. RECONFIRM DTC |
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at 6 km/h (4 mph) or more to activate the initial check.
Check if the same DTC(s) is output (Click here).
Result Result
Proceed to
DTC is output
A
DTC is not output
B
|
|
||||
| A | ||
| ||
