Home › BODY › SLIDING ROOF › SLIDING ROOF SYSTEM
B2341 Sensor (Motor) Failure
Diagnostic trouble codes · Vehicles built Nov 2005 – Jul 2008
Also covers:
Versions by build date: Nov 2005 – Jul 2008 from Aug 2008
DESCRIPTION
When the sliding roof drive gear (sliding roof ECU) detects the motor's malfunction, and the sliding roof operation is stopped, DTC B2341 is output. When the sliding roof drive gear (sliding roof ECU) detects the gear's malfunction, and the sliding roof operation is stopped, DTC B2344 is output.
DTC No.
DTC Detection Condition
Trouble Area
B2341
Sensor (motor) Failure
Sliding roof drive gear sub-assembly (sliding roof ECU)
Overhead junction block (sliding roof control switch)
Wire harness
B2344
Position Failure
Sliding roof drive gear sub-assembly (sliding roof ECU)
Overhead junction block (sliding roof control switch)
Wire harness
WIRING DIAGRAM
INSPECTION PROCEDURE
1. CHECK SLIDING ROOF FUNCTION
Check the auto operation with the SLIDE OPEN and TILT UP switch (Click here ).
OK:
Auto operation operates normally with SLIDE OPEN and TILT UP switch.
NG
OK
2. DELETE DTC
Delete the DTC (Click here ).
NEXT
3. INITIALIZE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU)
Check that the sliding roof drive gear can be initialized (Click here ).
OK:
Sliding roof drive gear can be initialized.
NG
OK
4. CHECK SLIDING ROOF FUNCTION
Check the auto operation with the SLIDE OPEN and TILT UP switch (Click here ).
OK:
Auto operation operates normally with SLIDE OPEN and TILT UP switch.
NG
REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU)
OK
5. DELETE DTC
Delete the DTC (Click here ).
NEXT
6. CHECK WIRE HARNESS (SLIDING ROOF DRIVE GEAR - OVERHEAD JUNCTION BLOCK)
Disconnect the R9 ECU connector.
Disconnect the R8 junction block connector.
Measure the resistance of the wire harness side connectors.
Standard resistance:
Tester Connection
Specified Condition
R9-7 (DWN) - R8-9 (DOWN)
Below 1 Ω
R9-9 (UP) - R8-8 (UP)
Below 1 Ω
R9-7 (GND) - Body ground
Below 1 Ω
R9-7 (DWN) - Body ground
10 kΩ or higher
R9-9 (UP) - Body ground
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK
7. INSPECT OVERHEAD JUNCTION BLOCK (SLIDING ROOF CONTROL SWITCH)
Remove the overhead junction block.
Measure the resistance of the switch.
Standard resistance:
Tester Connection
Condition
Specified Condition
8 (UP) - 7 (GND)
TILT UP switch pushed
Below 1 Ω
8 (UP) - 7 (GND)
TILT UP switch not pushed
10 kΩ or higher
9 (DOWN) - 7 (GND)
SLIDE OPEN switch pushed
Below 1 Ω
9 (DOWN) - 7 (GND)
SLIDE OPEN switch not pushed
10 kΩ or higher
NG
REPLACE OVERHEAD JUNCTION BLOCK (SLIDING ROOF CONTROL SWITCH)
OK
REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU)