2005-2008 RAV4 · Service Manual HEATER & AIR CONDITIONING SYSTEM

B1422/22 Compressor Lock Sensor Circuit

Diagnostic trouble codes · Vehicles built from Aug 2007

DESCRIPTION

This sensor sends 1 pulse per engine revolution to the air conditioning amplifier. If the ratio of the compressor speed divided by the engine speed is smaller than a predetermined value, the air conditioning amplifier turns the compressor off, and the indicator blinks at approximately 1 second intervals.
DTC No.
DTC Detection Condition
Trouble Area
B1422/22
Open or short in compressor lock sensor circuit
All conditions below are detected for 3 seconds or more:
1. Engine speed: 450 rpm or more
2. Ratio between engine and compressor speed deviates 20% or more in comparison to normal operation
  1. Compressor and magnetic clutch
  2. Compressor and magnetic clutch drive belt
  3. Compressor lock sensor
  4. Harness and connector between compressor lock sensor and air conditioning amplifier
  5. Air conditioning amplifier

WIRING DIAGRAM

E127541E01

INSPECTION PROCEDURE


1. CHECK AIR CONDITIONING AMPLIFIER (LOCK SIGNAL)
E127542E02
  1. Remove the air conditioning amplifier with its connectors still connected.

  1. Check the waveform of the amplifier connector.

    OK:
    Waveform is as shown in the illustration.

    Item
    Content
    Tester Connection
    LOCK (E41-8) - SG-2 (E41-13)
    Tool Setting
    500 mV/DIV., 20 msec./DIV.
    Condition
    Ignition switch on (IG)
    AUTO switch ON
    A/C switch ON
    Magnetic clutch ON

    Result:
    Result
    Proceed to
    NG
    A
    OK (Checking from the PROBLEM SYMPTOMS TABLE)
    B
    OK (Checking from the DTC)
    C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

C
REPLACE AIR CONDITIONING AMPLIFIER
A


2. INSPECT COMPRESSOR LOCK SENSOR
E127543E01
  1. Disconnect the B82 compressor lock sensor connector.

  1. Measure the resistance of the sensor.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (SSR+) - 2 (SSR-)
    20°C (68°F)
    65 to 125 Ω



NG
REPLACE COMPRESSOR LOCK SENSOR
OK


3. CHECK WIRE HARNESS (COMPRESSOR LOCK SENSOR - AIR CONDITIONING AMPLIFIER)
E127544E02
  1. Disconnect the B82 compressor lock sensor connector.

  1. Disconnect the E41 amplifier connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    B82-1 (SSR+) - E41-8 (LOCK)
    Below 1 Ω
    B82-2 (SSR-) - E41-13 (SG-2)
    Below 1 Ω
    B82-1 (SSR+) - E41-13 (SG-2)
    10 kΩ or higher
    E41-8 (LOCK) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER


← B1421/21 Solar Sensor Circuit (Passenger Side) (from Nov 2005)B1423/23 Pressure Sensor Circuit (from Nov 2005) →