Compressor Circuit
Circuit diagnosis · Vehicles built from Aug 2007
DESCRIPTION
When the A/C switch is turned on, the magnetic clutch ON signal is sent from the air conditioning amplifier. Then the MG CLT relay turns on to operate the magnetic clutch.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (A/C MAG CLUTCH) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the intelligent tester main switch ON.
Select the item below in the ACTIVE TEST and then check that the compressor magnetic relay operates.
Air conditioning amplifier Item
Test Details / Display (Range)
Diagnostic Note
Magnetic Clutch Relay
Magnetic clutch relay / OFF, ON
Operating sound can be heard
|
|
||||
| OK | ||
| ||
| 2. INSPECT FUSE (ECU-IG1) |
Remove the ECU-IG1 fuse from the instrument panel junction block.
Measure the resistance of the fuse.
- Standard resistance:
- Below 1 Ω
|
|
||||
| OK | |
| 3. INSPECT MAGNETIC CLUTCH RELAY (Marking: MG CLT) |
![]() ![]() |
Remove the magnetic clutch relay from the engine room No. 1 relay block.
Measure the resistance of the relay.
- Standard resistance:
Tester Connection
Specified Condition
3 - 5
10 kΩ or higher
3 - 5
Below 1 Ω
(when battery voltage is applied to terminals 1 and 2)
|
|
||||
| OK | |
| 4. CHECK WIRE HARNESS (AIR CONDITIONING AMPLIFIER - BATTERY) |
![]() ![]() |
Disconnect the E42 amplifier connector.
Measure the voltage of the wire harness side connector.
- Standard voltage:
Tester Connection
Condition
Specified Condition
E42-15 (MGC) - Body ground
Ignition switch on (IG)
10 to 14 V
E42-15 (MGC) - Body ground
Ignition switch off
Below 1 V
|
|
||||
| OK | |
| 5. CHECK AIR CONDITIONING AMPLIFIER (MGC VOLTAGE) |
![]() ![]() |
Remove the air conditioning amplifier with its connectors still connected.
Measure the voltage of the connector.
- Standard voltage:
Tester Connection
Condition
Specified Condition
E42-15 (MGC) - Body ground
Ignition switch on (IG)
A/C switch OFF
10 to 14 V
E42-15 (MGC) - Body ground
Ignition switch on (IG)
A/C switch ON
Below 1 V
|
|
||||
| OK | |
| 6. CHECK MAGNETIC CLUTCH |
![]() ![]() |
Disconnect the B82 magnetic clutch connector.
Connect the battery's positive (+) lead to terminal 3 of the magnetic clutch and the negative (-) lead to the body ground.
- OK:
- Magnetic clutch is engaged.
|
|
||||
| OK | ||
| ||




