2005-2008 RAV4 · Service Manual BRAKE

C1379 Downhill Assist Control Switch Malfunction (Test Mode DTC)

Diagnostic trouble codes · Vehicles built from Aug 2008

DESCRIPTION

DTC C1379 will be cleared when the downhill assist control switch sends a downhill assist control operation signal or when Test Mode ends. DTC C1379 is stored only in Test Mode.
DTC Code
DTC Detection Condition
Trouble Area
C1379
Stored only during Test Mode.
Downhill assist control switch

WIRING DIAGRAM

C197333E02

INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).


1. READ VALUE USING INTELLIGENT TESTER (DOWNHILL ASSIST CONTROL SWITCH)
  1. Check the Data List for proper functioning of the downhill assist control switch.

    ABS/VSC/TRC: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Downhill Assist Control Switch
    Downhill assist control switch / ON or OFF
    ON: Downhill assist control switch is on
    OFF: Downhill assist control switch is off
    -

    OK:
    The intelligent tester displays ON or OFF according to downhill assist control switch operation.



NG
Go to step 3
OK


2. PERFORM TEST MODE (SIGNAL CHECK)
  1. Turn the ignition switch off.

  1. Perform the sensor check in the Test Mode procedure (Click here).

    OK:
    All Test Mode DTCs are cleared.

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).



NG
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (Click here)

3. INSPECT DOWNHILL ASSIST CONTROL SWITCH

  1. C128533E07
    Turn the ignition switch off.

  1. Make sure that there is no looseness in the locking part and connecting part of the connector.

  1. Disconnect the downhill assist control switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 4
    Switch is pushed
    Below 1 Ω
    Switch is not pushed
    10 kΩ or higher

    NOTICE:
    Check the downhill assist control switch signal after replacement (Click here).



NG
REPLACE DOWNHILL ASSIST CONTROL SWITCH (Click here)
OK


4. CHECK HARNESS AND CONNECTOR (DOWNHILL ASSIST CONTROL SW - SKID CONTROL ECU/BODY GROUND)

  1. C194144E02
    Disconnect the skid control ECU connector.

  1. Disconnect the downhill assist control switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A67-29 (HDCS) - E36-4
    Always
    Below 1 Ω
    A67-29 (HDCS) - Body ground
    Always
    10 kΩ or higher
    E36-1 - Body ground
    Always
    Below 1 Ω

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← C1337/37 Different Diameter Tire Malfunction (Aug 2007 – Jul 2008)C1379/74 Downhill Assist Control Operation Switch (Test Mode DTC) (Nov 2005 – Dec 2006) →