2005-2008 RAV4 · Service Manual STEERING

INSPECTION

Inspection · Vehicles built from Nov 2005


INSPECT TIE ROD END SUB-ASSEMBLY LH

C132329
  1. Secure the tie rod end sub-assembly LH ball joint in a vise through aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. Install the castle nut to the stud bolt.

  1. Flip the ball joint back and forth 5 times.

  1. Set a torque wrench to the nut, turn the ball joint continuously at a rate of 3 to 5 seconds per turn, and check the turning torque on the 5th turn.

    Standard turning torque:
    0.98 to 3.92 N*m (10.0 to 39.9 kgf*cm, 9 to 34 in.*lbf)

    If turning torque is out of specification, replace the tie rod end sub-assembly LH with a new one.


INSPECT TIE ROD END SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the tie rod end sub-assembly LH.


INSPECT TOTAL PRELOAD

  1. C151612E01
    Using SST, inspect the total preload.
    SST
    09616-00011  

    Standard total preload (turning):
    0.7 to 1.3 N*m (7.1 to 13.2 kgf*cm, 6 to 11 in.*lbf)

    NOTICE:
    Inspect around the steering rack center position.

    If the total preload is out of specification, replace the steering gear with a new one.

← REMOVAL (from Aug 2007)INSTALLATION (Nov 2005 – Dec 2006) →