2005-2008 RAV4 · Service Manual STEERING

REMOVAL

Removal / installation · Vehicles built from Aug 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007


1. POSITION FRONT WHEELS FACING STRAIGHT AHEAD

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


3. REMOVE FRONT WHEELS

4. DISCONNECT TIE ROD END SUB-ASSEMBLY LH
  1. Remove the cotter pin and castle nut.

  1. C132680E01
    Using SST, disconnect the tie rod end from the steering knuckle.

    NOTICE:
    Do not damage the tie rod end dust cover.

    SST
    09628-62011  


5. DISCONNECT TIE ROD END SUB-ASSEMBLY RH

HINT:
Use the same procedure for the RH side as for the LH side.


6. REMOVE COLUMN HOLE COVER SILENCER SHEET

  1. C128486
    Remove the floor carpet, 2 clips and column hole cover silencer.


7. DISCONNECT STEERING SLIDING YOKE SUB-ASSEMBLY

  1. C128836
    Use a seat belt to fix the steering wheel in place to avoid breakage of the spiral cable.

  1. C128488E01
    Place matchmarks on the sliding yoke of the steering intermediate shaft.

  1. Remove the bolt and disconnect the sliding yoke.


8. DISCONNECT NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY

  1. C128837E01
    Remove clip A, detach clip B from the body and disconnect the No. 1 steering column hole cover.

    NOTICE:
    Do not damage clips A and B.


9. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
  1. for 1AZ-FE:
    Remove the engine with transaxle (Click here).

  1. for 2AZ-FE:
    Remove the engine with transaxle (Click here).

  1. for 2GR-FE:
    Remove the engine with transaxle (Click here).

  1. for 2AD-FHV:
    Remove the engine with transaxle (Click here).

  1. for 2AD-FTV:
    Remove the engine with transaxle (Click here).


10. REMOVE NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY
  1. Remove the clamp and disconnect the column hole cover from the steering gear.


11. REMOVE INTERMEDIATE SHAFT

C132129E01
  1. Place matchmarks on the intermediate shaft of the steering gear.

  1. Remove the bolt and disconnect the steering intermediate shaft from the steering gear.


12. REMOVE STEERING GEAR ASSEMBLY

C128838
  1. Remove the 2 bolts, 2 nuts and steering gear from the suspension crossmember.

    NOTICE:
    Keep the nut from rotating while turning the bolt.


13. SECURE STEERING GEAR ASSEMBLY

  1. C151611E02
    Using SST wrapped with protective tape, secure the steering gear in a vise.
    SST
    09612-00012  

    HINT:
    Remove and reinstall SST as needed.


14. REMOVE TIE ROD END SUB-ASSEMBLY LH

  1. F040050E19
    Put matchmarks on the No. 2 tie rod end subassembly and rack end.

  1. Remove the No. 2 tie rod end sub-assembly and lock nut.


15. REMOVE TIE ROD END SUB-ASSEMBLY RH

HINT:
Use the same procedure described for the No. 2 tie rod end sub-assembly.

← REMOVAL (Jan 2007 – Jul 2007)INSPECTION (from Nov 2005) →