2005-2008 RAV4 · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Aug 2008

Versions by build date: Nov 2005 – Jul 2008 from Aug 2008


1. REMOVE REAR BUMPER COVER

B208480E01
  1. Put protective tape around the bumper cover.

    NOTICE:
    When removing the rear bumper cover, as the flange of the rear bumper cover forcefully contacts the back door, apply a thick layer of protective tape.

  1. Fully open the back door.

  1. B208481E01
    Remove the 7 screws and 7 clips.

  1. B208483
    Detach the 12 claws.

  1. B207740E01
    Open the back door one notch and following the order in the illustration, pull down the left side of the cover, then pull down the right side of the cover and remove it by pulling it out from between the back door and body.


2. REMOVE REAR NO. 1 BUMPER REINFORCEMENT

B208578
  1. Remove the 6 bolts and reinforcement.


3. REMOVE REAR BUMPER SIDE SUPPORT LH

B208579
  1. Remove the 2 screws.

  1. Using a screwdriver, detach the claw and remove the side support.

    HINT:
    Tape the screwdriver tip before use.


4. REMOVE REAR BUMPER SIDE SUPPORT RH

HINT:
Use the procedure described for the LH side.


5. REMOVE REAR BUMPER UPPER RETAINER LH

B208580
  1. Remove the screw.

  1. Using a screwdriver, detach the claw and remove the upper retainer.

    HINT:
    Tape the screwdriver tip before use.


6. REMOVE REAR BUMPER UPPER RETAINER RH

HINT:
Use the procedure described for the LH side.


7. REMOVE REAR NO. 1 BUMPER PLATE (w/ License Plate Light)

B208487
  1. Detach the 7 clips and 3 guides, and remove the bumper plate.


8. REMOVE LICENSE PLATE LIGHT ASSEMBLY (w/ License Plate Light)
  1. Disconnect the connector.

  1. B132930E02
    Using a screwdriver, remove the light as shown in the illustration.


9. REMOVE REFLEX REFLECTOR ASSEMBLY LH

B208484
  1. Remove the screw and reflex reflector.


10. REMOVE REFLEX REFLECTOR ASSEMBLY RH

HINT:
Use the procedure described for the LH side.


11. REMOVE REAR BUMPER SIDE MOULDING SUB-ASSEMBLY LH (for Wide Body)

B208508
  1. Remove the screw.

  1. Detach the 5 clips and remove the side moulding.


12. REMOVE REAR BUMPER SIDE MOULDING SUB-ASSEMBLY RH (for Wide Body)

HINT:
Use the procedure described for the LH side.

← REMOVAL (Nov 2005 – Jul 2008)INSTALLATION (Nov 2005 – Jul 2008) →