Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the cruise control system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the intelligent tester (with CAN VIM) to check if the CAN communication system is functioning normally.
      Result 
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B



    B.
    Go to CAN COMMUNICATION SYSTEM
    A


    4.CHECK INDICATOR LIGHT

      NEXT


      5.CHECK DTC*
      1. Check for DTCs (Click here).

      2. Clear the DTCs (Click here).

      3. Recheck for DTCs (Click here).

      4. Result 
        Result
        Proceed to
        DTC does not reoccur
        A
        DTC reoccurs
        B


      B.
      Go to step 10
      A


      6.PROBLEM SYMPTOMS TABLE

        Result 
        Result
        Proceed to
        Fault is not listed in problem symptoms table
        A
        Fault is listed in problem symptoms table
        B


      B.
      Go to step 8
      A


      7.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. Terminals of ECM (Click here)

      2. Data List / Active Test (Click here )


      NEXT


      8.REPAIR OR REPLACE

        NEXT


        9.CONFIRMATION TEST

          NEXT

          END


          10.DIAGNOSTIC TROUBLE CODE CHART
          1. Diagnostic trouble code chart (Click here)


          NEXT


          11.REPAIR OR REPLACE

            NEXT


            12.CONFIRMATION TEST

              NEXT

              END