Home › ENGINE ยท 2AD-FTV › ENGINE CONTROL SYSTEM › MASS AIR FLOW METER

MASS AIR FLOW METER > ON-VEHICLE INSPECTION

for Preparation Click here


NOTICE:
  1. Perform the MAF meter inspection according to the procedures below.
  2. Only replace the MAF meter when the MAF value in the DATA LIST (with the engine stopped) is not within the normal operating range.



1. CHECK MASS AIR FLOW METER SUB-ASSEMBLY


  1. Check the mass air flow value.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / MAF.



    5. A204312
    6. Blow air into the MAF meter, and check that the MAF value fluctuates.

      1. for CCo:
        If the result is not as specified, check the MAF meter, or wiring and ECM (Click here).
      2. for DPF:
        If the result is not as specified, check the MAF meter, or wiring and ECM (Click here).