DTC C1427 Motor Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1427 | Actuator pump motor does not operate properly. |
|
| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (MOTOR RELAY) |
Connect the intelligent tester to the DLC3.
Start the engine.
Select the Active Test mode on the intelligent tester (Click here).
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Motor Relay | Motor relay | Relay ON / OFF | Operating sound of motor can be heard. |
Check for operating sound of the motor relay when operating it with the intelligent tester.
| Result | Proceed to |
| Operating sound is not heard. | A |
| Operating sound is heard. | B |
|
| ||||
| A | |
| 2.INSPECT SKID CONTROL ECU (GND2 TERMINAL) |
![]() |
Turn the ignition switch off.
Make sure that there is no looseness in the locking part and connecting part of the connectors.
Disconnect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A67-13 (GND2) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Turn the ignition switch off.
Reconnect the skid control ECU connector.
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at a speed of 20 km/h (12 mph) or more for 30 seconds or more.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC (C1427) is not output. | A |
| DTC (C1427) is output. | B |
|
| ||||
| A | ||
| ||