Manual Transaxle System
Symptom
| Suspected Area
| See page
|
Noise
| 1. Oil level (low)
|
Click here
|
2. Oil grade (wrong)
|
Click here
|
3. Gear (worn or damage)
|
Click here
|
4. Bearing (worn or damaged)
|
Click here
|
Oil leakage
| 1. Oil level
|
Click here
|
2. Gasket
|
Click here
|
3. Oil seal
|
Click here
|
4. O-ring
|
Click here
|
Hard to shift or does not shift
| 1. Synchronizer ring
|
Click here
|
2. Shift key spring
|
Click here
|
Jumps out of gear
| 1. Locking ball spring
|
Click here
|
2. Shift fork (worn)
|
Click here
|
3. Gear (worn or damaged)
|
Click here
|
4. Bearing (worn or damaged)
|
Click here
|
The shift lever does not move (or the shift lever is difficult to move) to the 1st or 2nd position.
| 1. Control cable (Adjustment)
|
Click here
|
It is possible to move the shift lever to the reverse position without pulling up the slider shaft.
| 1. Control cable (Adjustment)
|
Click here
|