Home › ENGINE ยท 2AD-FTV › ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
w/ Navigation System (for HDD):
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE MANUAL TRANSAXLE ASSEMBLY
  1. for 4WD:
    Remove the manual transaxle (Click here).

  1. for 2WD:
    Remove the manual transaxle (Click here).



3. REMOVE CLUTCH COVER ASSEMBLY


    C113575E07
  1. Align the matchmarks on the clutch cover and flywheel.

  1. Loosen each set bolt 180°at a time until the spring tension is released.

    NOTICE:
    Following the order in the illustration, make sure to uniformly loosen the bolts 180°at a time.

  1. Remove the set bolts, and pull off the clutch cover.

    NOTICE:
    Do not drop the clutch disc.



4. REMOVE CLUTCH DISC ASSEMBLY

NOTICE:
Keep the lining part of the clutch disc, the pressure plate and the surface of the flywheel away from oil and foreign matter.



5. REMOVE FLYWHEEL SUB-ASSEMBLY


    A201753E01
  1. Hold the crankshaft pulley with SST.

    SST
    09213-58014   (91551-80840)
    09330-00021  



    A202344
  1. Using a T55 "TORX" socket wrench, remove the 8 bolts and flywheel.



6. REMOVE REAR CRANKSHAFT OIL SEAL


    A123733E01
  1. Using a knife, cut off the lip of the oil seal.

  1. Using a screwdriver, pry out the oil seal.

    NOTICE:
    Be careful not to damage the crankshaft.