Home › TRANSMISSION ยท CLUTCH › CLUTCH UNIT (for 2AD-FTV, 2AD-FHV)

CLUTCH UNIT (for 2AD-FTV, 2AD-FHV) > REMOVAL

for Preparation Click here



1. REMOVE MANUAL TRANSAXLE ASSEMBLY
  1. for EA64:
    Remove the manual transaxle (Click here).

  1. for EA64F:
    Remove the manual transaxle (Click here).



2. REMOVE CLUTCH RELEASE FORK SUB-ASSEMBLY


    C113576
  1. Remove the clutch release fork with clutch release bearing from the transaxle.



3. REMOVE CLUTCH RELEASE BEARING ASSEMBLY


    C116601
  1. Remove the clutch release bearing from the clutch release fork.



4. REMOVE RELEASE FORK SUPPORT


    C113601
  1. Remove the release fork support from the transaxle.



5. REMOVE CLUTCH RELEASE FORK BOOT


    C113599E01
  1. Remove the clutch release fork boot from the transaxle case.



6. REMOVE CLUTCH COVER ASSEMBLY


    C113575E07
  1. Align the matchmarks on the clutch cover and flywheel.

  1. Loosen each set bolt 180°at a time until the spring tension is released.

    NOTICE:
    Following the order in the illustration, make sure to uniformly loosen the bolts 180°at a time.

  1. Remove the set bolts, and pull off the clutch cover.

    NOTICE:
    Do not drop the clutch disc.



7. REMOVE CLUTCH DISC ASSEMBLY

NOTICE:
Keep the lining part of the clutch disc, the pressure plate and the surface of the flywheel away from oil and foreign matter.