DTC P2226 Barometric Pressure Circuit |
DTC P2228 Barometric Pressure Circuit Low Input |
DTC P2229 Barometric Pressure Circuit High Input |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Ignition switch ON for 1 second | Atmospheric pressure sensor voltage is 1.4 V or less, or 4.0 V or higher for 0.5 seconds. (1 trip detection logic) | ECM |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Ignition switch ON for 1 second | Atmospheric pressure sensor voltage is 1.4 V or less for 0.5 seconds. (1 trip detection logic) | ECM |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Ignition switch ON for 1 second | Atmospheric pressure sensor voltage is 4.0 V or higher for 0.5 seconds. (1 trip detection logic) | ECM |
| DTC No. | Data List |
| P2226 |
|
| P2228 | |
| P2229 |
| 1.REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 2.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Clear the DTCs (Click here).
Turn the ignition switch to ON and wait for 1 second or more.
Confirm that the DTC is not output again.
| NEXT | ||
| ||