Home › TRANSMISSION ยท CLUTCH › CLUTCH UNIT (for 2AD-FTV, 2AD-FHV)

CLUTCH UNIT (for 2AD-FTV, 2AD-FHV) > INSTALLATION

for Preparation Click here



1. INSTALL CLUTCH DISC ASSEMBLY


    C116730E01
  1. Insert SST into the clutch disc, and then insert them into the flywheel.

    SST
    09301-00310  

    NOTICE:
    Do not insert the clutch disc in the wrong direction.



2. INSTALL CLUTCH COVER ASSEMBLY


    C116732E02
  1. Align the matchmarks on the clutch cover with the one on the flywheel.

  1. Tighten the 6 bolts uniformly in the order shown in the illustration, starting with the bolt located near the knock pin on the top.

    Torque:
    19 N*m{ 195 kgf*cm , 14 ft.*lbf }

    NOTICE:
    1. Following the order in the illustration, make sure to uniformly tighten the bolts 180°.
    2. After checking that the disc is in the center, gently move SST up and down, and right and left to tighten the bolts.



3. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY


    C116193
    C116192E01
  1. Using a dial indicator with a roller instrument, measure the diaphragm spring tip alignment.

    Maximum non-alignment:
    1.3 mm (0.050 in.)

    If the alignment is not as specified, using SST, adjust the diaphragm spring tip alignment.
    SST
    09333-00013  



4. INSTALL RELEASE FORK SUPPORT


    C113601
  1. Install the release fork support to the transaxle.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }



5. INSTALL CLUTCH RELEASE FORK BOOT


    C113599
  1. Install the clutch release fork boot onto the transaxle case.



6. INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY


    C133433
  1. Apply release hub grease to the contact surfaces of the release fork and release bearing, fork and push rod, and fork and fork support.

    Release hub grease:
    Part No. 08887-01806, RELEASE HUB GREASE or equivalent

  1. Install the fork to the release bearing.



7. INSTALL CLUTCH RELEASE BEARING ASSEMBLY


    C133434
  1. Apply clutch spline grease to the input shaft spline.

    Clutch spline grease:
    Part No. 08887-01706, CLUTCH SPLINE GREASE or equivalent



    C113576
  1. Install the bearing with release fork to the transaxle.

    NOTICE:
    After the installation, move the fork forward and backward to check that the release bearing slides smoothly.



8. INSTALL MANUAL TRANSAXLE ASSEMBLY
  1. for EA64:
    Install the manual transaxle (Click here).

  1. for EA64F:
    Install the manual transaxle (Click here).