Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System)

ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System) > DIAGNOSTIC TROUBLE CODE CHART

for Preparation Click here



Certification ECU: 
DTC Code
Detection Item
Trouble Area
See page
B2784
Antenna Coil Open / Short
- Engine switch
- ECU aggregation box (certification ECU)
Click here
B2785
Communication Malfunction between ECUs Connected by LIN
- Wire harness
- ECU aggregation box (certification ECU)
- Instrument panel junction block (main body ECU)
- Steering lock actuator (steering lock ECU)
- ID code box
Click here
B2789
No Response from ID BOX
- Wire harness
- ECU aggregation box (certification ECU)
- ID code box
Click here
B278A
Short to GND in Immobiliser System Power Source Circuit
- Wire harness
- Engine switch
- ECU aggregation box (certification ECU)
Click here
B2790
ID BOX EEPROM Malfunction
ID code box
Click here
B2791
Communication Condition Failure between ECM
- Wire harness
- ECU aggregation box (certification ECU)
- Instrument panel junction block (main body ECU)
- Steering lock actuator (steering lock ECU)
- ID code box
- ECM
Click here

HINT:
The DTCs for the engine immobiliser system are specified above. If other codes are output, check the DTC chart for the engine control system.


ECM: 
DTC Code
Detection Item
Trouble Area
See page
B2799
Engine Immobiliser System Malfunction
- Wire harness
- ID code box
- ECM
Click here
B279A
Theft Deterrent System Communication Line High Fixation
- Wire harness
- ID code box
- ECM
Click here
B279C
Theft Deterrent System Presence Detection
ECM
Click here