Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System)

ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the engine immobiliser system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CRANK ENGINE FOR MORE THAN 10 SECONDS

      NEXT


      4.CHECK FOR DTC*
      1. Check for DTCs and make a note of any codes that are output (Click here).

      2. Clear the DTC.

      3. Recheck for DTCs. Based on the DTC output in the first step, try to cause the output of the same, ECD system DTC or engine immobiliser system DTC by simulating the original activity indicated by the DTC.
        Result: 
        Result
        Proceed to
        DTC output does not reoccur
        A
        ECD system DTC output reoccurs
        B
        Engine immobiliser system DTC output reoccurs
        C



      B.
      Go to ECD SYSTEM

      C.
      Go to step 7
      A


      5.PROBLEM SYMPTOMS TABLE
        Result: 
        Result
        Proceed to
        Fault is not listed in problem symptoms table
        A
        Fault is listed in problem symptoms table
        B


      B.
      Go to step 7
      A


      6.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. Data List / Active Test (Click here)

      2. Terminals of ECU (Click here)

      3. Inspection (Click here)


      NEXT


      7.ADJUST, REPAIR OR REPLACE

        NEXT


        8.CONFIRMATION TEST

          NEXT

          END