DTC B2799 Engine Immobiliser System Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2799 | One of following conditions is met:
|
|

| 1.CHECK FOR DTC |
Clear the DTC (Click here).
Recheck for DTC.
|
| ||||
| OK | ||
| ||
| 2.CHECK WIRE HARNESS (TRANSPONDER KEY ECU - ECM) |
![]() |
Disconnect the E50 ECU connector.
Disconnect the A12 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Condition | Specified Condition |
| E50-13 (EFIO) - A12-16 (IMI) | Always | Below 1 Ω |
| E50-12 (EFII) - A12-15 (IMO) | Always | |
| E50-13 (EFIO) or A12-16 (IMI) - Body ground | Always | 10 kΩ or higher |
| E50-12 (EFII) or A12-15 (IMO) - Body ground | Always |
|
| ||||
| OK | |
| 3.CHECK TRANSPONDER KEY ECU (OPERATION) |
Temporarily replace the transponder key ECU with a new one.
Check that the engine starts normally.
| Result | Proceed to |
| OK | A |
| NG (for 2AD-FHV) | B |
| NG (for 2AD-FTV) | C |
|
| ||||
|
| ||||
| A | ||
| ||