SKID CONTROL SENSOR (for 2WD) > INSTALLATION |
| 1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH (SKID CONTROL SENSOR) |
Install the rear axle hub and bearing LH (Click here).
| 2. INSTALL REAR DISC |
![]() |
Align the matchmarks and install the disc.
| 3. INSTALL REAR DISC BRAKE CYLINDER MOUNTING LH |
![]() |
Install the cylinder mounting with the 2 bolts.
| 4. INSTALL SKID CONTROL SENSOR WIRE |
![]() |
Connect the skid control sensor wire connector (labeled A) to the skid control sensor.
Install the sensor clamp (labeled B) with the bolt (labeled C).
![]() |
Install the sensor clamps (labeled D) with the 2 nuts (labeled E).
Install the sensor clamp (labeled F) with the bolt (labeled G).
![]() |
Insert the connector and grommet into the inside of the vehicle through the passage hole in the wheel house.
![]() |
Hold the grommet and pull it toward the outside of the vehicle. Then fix the grommet in place so that it is not tilted.
![]() |
Connect the skid control sensor wire connector.
| 5. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH |
Install the deck trim side panel LH (Click here).
| 6. INSTALL REAR WHEEL |
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 8. CHECK SPEED SENSOR SIGNAL |
w/o VSC:
Check the speed sensor signal (Click here).
w/ VSC:
Check the speed sensor signal (Click here).