Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB

FRONT AXLE HUB > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE FRONT WHEEL


2. REMOVE DISC BRAKE CYLINDER ASSEMBLY
  1. Remove the front disc brake cylinder assembly (Click here).



3. REMOVE FRONT DISC


    C127063E01
  1. Put matchmarks on the disc and axle hub.

  1. Remove the disc.



4. CHECK FRONT AXLE HUB BEARING


    C127532E01
  1. Inspect the axle hub backlash.

    1. Using a dial indicator, measure the backlash near the center of the axle hub.

      Maximum backlash:
      0.05 mm (0.00197 in.)

      1. If the backlash is greater than the maximum, replace the bearing.

  1. Inspect the axle hub deviation.

    1. Using a dial indicator, measure the deviation on the surface of the axle hub.

      Maximum deviation:
      0.05 mm (0.00197 in.)

      1. If the deviation is greater than the maximum, replace the bearing.



5. INSTALL FRONT DISC


    C127063E01
  1. Align the matchmarks and install the disc.

    HINT:
    When replacing the disc with a new one, select the installation position where the disc has the minimum runout.



6. INSTALL DISC BRAKE CYLINDER ASSEMBLY
  1. Install the front disc brake cylinder assembly (Click here).



7. INSTALL FRONT WHEEL