Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB BOLT

FRONT AXLE HUB BOLT > REPLACEMENT

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are the LH side.



1. REMOVE FRONT WHEEL


2. REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH
  1. Remove the front disc brake cylinder assembly (Click here).



3. REMOVE FRONT DISC


    C127063E01
  1. Put matchmarks on the disc and axle hub.

  1. Remove the disc.



4. REMOVE FRONT AXLE HUB BOLT


    C130491E01
  1. Using SST, remove the hub bolt that needs to be replaced.

    SST
    09650-17011  



5. INSTALL FRONT AXLE HUB BOLT


    C159674E03
  1. Insert a new hub bolt into the bolt hole. Set a plate washer and nut on the hub bolt end.

  1. Using a brass bar or equivalent to hold the front axle, install the hub bolt by tightening the nut. Then remove the nut and plate washer.



6. INSTALL FRONT DISC


    C127063E01
  1. Align the matchmarks and install the disc.

    HINT:
    When replacing the disc with a new one, select the installation position where the disc has the minimum runout.



7. INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY LH
  1. Install the front disc brake cylinder assembly (Click here).



8. INSTALL FRONT WHEEL

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }