Home › HEATER & AIR CONDITIONING SYSTEM › HEATER › COMBUSTION TYPE POWER HEATER SYSTEM

COMBUSTION TYPE POWER HEATER SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the combustion type power heater system.
  2. *: Use the DTC tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK

      NEXT


      3.INSPECT BATTERY VOLTAGE
      1. Measure the battery voltage.

        Standard voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


      NEXT


      4.CHECK FOR DTC*
      1. Check for DTCs and note any codes that are output (Click here).

      2. Clear the DTCs (Click here).

      3. Recheck for DTCs (Click here).
        Result 
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B



      B.
      Go to DIAGNOSTIC TROUBLE CODE CHART (Click here)
      A


      5.PROBLEM SYMPTOMS TABLE
      1. Refer to the Problem Symptoms Table (Click here).
        Result 
        Result
        Proceed to
        Fault is not listed in problem symptoms table
        A
        Fault is listed in problem symptoms table
        B



      B.
      GO TO STEP 7
      A


      6.OVERALL ANALYSIS AND TROUBLESHOOTING
      1. Terminals of ECU (Click here)

      2. On-vehicle Inspection

      3. Inspection


      NEXT


      7.ADJUST, REPAIR OR REPLACE

        NEXT


        8.CONFIRMATION TEST

          NEXT

          END