DTC P0741 Torque Converter Clutch Solenoid Performance (Shift Solenoid Valve SL) |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0741 | Both conditions are met (2-trip detection logic):
|
|

| ACTIVE TEST |
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / ECT / Active Test.
According to the display on the tester, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Activate the Lock Up | Control shift solenoid valve SLU and SL to set the automatic transaxle to lock-up | ON or OFF | Can be used to check shift solenoid valve SLU and SL operation. [Vehicle Condition]
|
Lightly depress the accelerator pedal and check that the engine speed does not change abruptly.

| 1.CHECK DTC OUTPUT (IN ADDITION TO DTC P0741) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / ECT / DTC.
Read the DTCs using the intelligent tester.
| Result | Proceed to |
| Only P0741 is output | A |
| P0741 and other DTCs are output | B |
|
| ||||
| A | |
| 2.INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE SL) |
![]() |
Remove the TCM.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 6 (SL) - Body ground | 20°C (68°F) | 11 to 15 Ω |
| *1 | Component without TCM connected (Transmission Wire) |
|
| ||||
| OK | |
| 3.INSPECT SHIFT SOLENOID VALVE SL (OPERATION) |
![]() |
Remove shift solenoid valve SL.
Apply 12 V battery voltage to the shift solenoid valve and check that the valve moves and makes an operating noise.
| Measurement Condition | Specified Condition |
| Valve moves and makes an operating noise |
| *1 | Component without harness connected (Shift Solenoid Valve SL) |
|
| ||||
| OK | |
| 4.INSPECT TRANSMISSION VALVE BODY ASSEMBLY |
Check the transmission valve body assembly (Click here).
|
| ||||
| OK | |
| 5.INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY |
Check the torque converter clutch assembly (Click here).
|
| ||||
| OK | ||
| ||
| 6.INSPECT SHIFT SOLENOID VALVE SL (RESISTANCE) |
![]() |
Remove shift solenoid valve SL.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Shift solenoid valve SL connector terminal - Shift solenoid valve SL body | 20°C (68°F) | 11 to 15 Ω |
| *1 | Component without harness connected (Shift Solenoid Valve SL) |
|
| ||||
| OK | ||
| ||