CYLINDER HEAD GASKET > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE EXHAUST MANIFOLD WITH TURBOCHARGER |
Remove the exhaust manifold with turbocharger (Click here).
| 3. REMOVE CAMSHAFT |
Remove the camshafts (Click here).
| 4. REMOVE EXHAUST FUEL ADDITION INJECTOR ASSEMBLY (for DPF) |
![]() |
Remove the bolt, washer, nozzle holder clamp, exhaust fuel addition injector and gasket.
| *1 | Washer |
| *2 | Nozzle Holder Clamp |
| 5. REMOVE FUEL INJECTOR SEAL (for DPF) |
![]() |
Remove the fuel injector seal from the exhaust fuel addition injector.
| 6. REMOVE GLOW PLUG ASSEMBLY |
![]() |
Remove the 4 grommets.
Remove the 4 nuts and No. 1 glow plug connector.
Using a 10 mm deep socket wrench, remove the 4 glow plugs.
| 7. REMOVE CYLINDER HEAD SUB-ASSEMBLY |
![]() |
Uniformly loosen the 10 bolts in several steps, in the sequence shown in the illustration. Remove the 10 cylinder head bolts and plate washers.
| 8. REMOVE CYLINDER HEAD GASKET |
![]() |
Remove the cylinder head gasket.