DTC P2141 Diesel Throttle Motor Circuit Low |
DTC P2142 Diesel Throttle Motor Circuit High |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Idle the engine for 5 seconds or more | The throttle actuator current is below 0.5 A for 2.0 seconds during EGR valve operation. (1 trip detection logic) |
|
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Idle the engine for 5 seconds or more | An throttle actuator current of 8 A or higher due to a mechanical malfunction, or a Hall IC temperature of 150 to 160°C (302 to 320°F) or higher is detected. (1 trip detection logic) |
|
| DTC No. | Data List |
| P2141 | Throttle Motor DUTY |
| P2142 |

| 1.INSPECT DIESEL THROTTLE BODY ASSEMBLY |
Inspect the diesel throttle body assembly (Click here).
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (ECM - DIESEL THROTTLE BODY) |
![]() |
Disconnect the diesel throttle body assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B107-2 (M+) - B32-42 (M+) | Always | Below 1 Ω |
| B107-1 (M-) - B32-43 (M-) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| B107-2 (M+) or B32-42 (M+) - Body ground | Always | 10 kΩ or higher |
| B107-1 (M-) or B32-43 (M-) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Diesel Throttle Body Assembly) |
| *2 | Front view of wire harness connector (to ECM) |
Reconnect the diesel throttle body assembly connector.
Reconnect the ECM connector.
|
| ||||
| OK | |
| 3.REPLACE ECM |
Replace the ECM (Click here).
|
| ||||
| 4.REPLACE DIESEL THROTTLE BODY ASSEMBLY |
Replace the diesel throttle body assembly (Click here).
|
| ||||
| 5.REPAIR OR REPLACE HARNESS OR CONNECTOR |
Repair or replace the harness or connector.
| NEXT | |
| 6.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent tester to the DLC3.
Clear the DTCs (Click here).
Start the engine.
Idle the engine for 5 seconds or more
Enter the following menus: Powertrain / Engine and ECT / DTC.
Confirm that the DTC is not output again.
| NEXT | ||
| ||