Home › TRANSMISSION ยท U660F AUTOMATIC TRANSAXLE › OIL COOLER

OIL COOLER > INSTALLATION

for Preparation Click here



1. INSTALL OIL COOLER TUBE SUB-ASSEMBLY

NOTICE:
Make sure the pinching portion of each clip is facing the direction shown in the illustration and the paint marks are aligned as shown in the illustration.



    C207609E01
  1. Install the No. 3 oil cooler inlet and outlet hoses, and No. 2 oil cooler inlet and outlet hoses to the oil cooler tube.
    Text in Illustration 
    *1
    White Paint Mark
    *2
    Yellow Paint Mark



    C207608E01
  1. Insert the pin of the fan shroud into the hole in the bracket and temporarily install the oil cooler tube with bolt C.

  1. Temporarily install bolt A and bolt B. Tighten the bolts in alphabetical order.
    Text in Illustration 
    *1
    Yellow Paint Mark
    *2
    Pin

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the No. 2 oil cooler inlet and outlet hoses to the radiator.



    C207607E01
  1. Install the No. 1 oil cooler inlet and outlet hoses to the transaxle.
    Text in Illustration 
    *1
    Light Blue Paint Mark
    *2
    Pink Paint Mark



    C207606E01
  1. Connect the No. 1 oil cooler inlet and outlet hoses to the oil cooler tube.
    Text in Illustration 
    *1
    White Paint Mark
    *2
    Yellow Paint Mark



2. INSTALL OIL COOLER ASSEMBLY


C207605E01
  1. Install the oil cooler with the 3 bolts.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

  1. Connect the No. 3 oil cooler inlet and outlet hoses to the oil cooler.
    Text in Illustration 
    *1
    Yellow Paint Mark
    *2
    White Paint Mark

    NOTICE:
    Make sure the paint marks and pinching portion of each clip are facing the direction shown in the illustration.



3. INSTALL FRONT BUMPER COVER
  1. w/ Under Guard:
    Install the front bumper cover (Click here).

  1. w/o Under Guard:
    Install the front bumper cover (Click here).



4. ADJUST AUTOMATIC TRANSAXLE FLUID
  1. Adjust the automatic transaxle fluid (Click here).