Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

DTC    C0226/21    SFR Solenoid Circuit

DTC    C0236/22    SFL Solenoid Circuit

DTC    C0246/23    SRR Solenoid Circuit

DTC    C0256/24    SRL Solenoid Circuit

for Preparation Click here


DESCRIPTION

This solenoid is turned on in accordance with signals from the skid control ECU and controls the pressure on the wheel cylinders to control the braking force.

DTC No.
DTC Detection Condition
Trouble Area
C0226/21
C0236/22
C0246/23
C0256/24
Open or short in solenoid circuit continues for 0.05 seconds or more.
Brake actuator (Skid control ECU)

HINT:
C0226/21, C0236/22, C0246/23, C0256/24:
The skid control ECU begins to detect these DTCs when the vehicle speed exceeds 6 km/h (4 mph).


WIRING DIAGRAM


C126280E03


INSPECTION PROCEDURE

1.RECONFIRM DTC
  1. Clear the DTC(s) (Click here).

  1. Start the engine.

  1. Drive the vehicle at 6 km/h (4 mph) or more to activate the initial check.

  1. Check if the same DTC(s) is output (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B

    HINT:
    The DTCs may be stored due to a malfunction in the connector terminal.



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)